Finger Slide

Dec. 9, 2010
The FDH Series finger slide uses a rail-bearing system for smooth operation

The FDH Series finger slide uses a rail-bearing system for smooth operation. The body, built from anodized aluminum with stainless rod coupler nuts, houses a repairable built-in air cylinder. Internal rubber bumpers provide a cushioned stop, and ports can be accessed from either side or the rear.

Additional features include a magnetic piston; four 4-mm keyhole sensor mounting slots (two per side); side through holes with counterbores in body; side, bottom, and rear-tapped mounting holes; tapped mounting holes on four surfaces; and toolbars, slightly narrower than body, allow side mounting with clearance between toolbar and mounting surface.

Fabco-Air Inc., 3716 N.E. 49th St., Gainesville, FL 32609, (352) 373-8024, www.fabco-air.com/pdf/FDH_finger_slide_web.pdf

© 2010 Penton Media, Inc.

Sponsored Recommendations

June 6, 2025
In the rapidly evolving landscape of industrial manufacturing, reliability, productivity, and worker safety take precedence. However, traditional connectivity approaches often...
June 6, 2025
Amidst the rapid evolution of electronics manufacturing, reliability, productivity, and worker safety remain paramount concerns. Yet, traditional connectivity methods often falter...
June 6, 2025
While many within the industrial manufacturing sector grasp the importance of smart manufacturing for optimizing processes, boosting productivity, and future-proofing operations...
June 6, 2025
For electronics manufacturers grappling with formidable challenges, navigating the path to success requires adapting to the dynamic landscape of the industry. How can electronics...

Voice your opinion!

To join the conversation, and become an exclusive member of Machine Design, create an account today!