Home

Polyamide rapid-prototyping powders- Rhodia

Jan. 3, 2011

The powders allow rapid prototyping of parts by SLS and other techniques.

Polyamide 6 (PA 6) powders for rapid prototyping and selective laser sintering (SLS) let users validate designs before cutting injection-molding tooling for PA parts. The range will be extended to include PA 66 powders.

Rhodia Engineering Plastics, 8 Cedar Brook Dr., Cranbury. NJ 08512, (609) 860-4000, www.rhodia.com

Continue Reading

Air Compressor Market Expected to Reach Nearly $69B by 2030

Designing a Winning Medal: What’s Behind the Flub of This Year’s Bronze Medals?

Sponsored Recommendations

Drive systems for urban air mobility

March 18, 2025

The shift of some of our transport traffic from the road to the air through urban air mobility is one of the most exciting future fields in the aerospace industry.

Blazing the trail for flying robots

March 18, 2025

Eight Bachelor students built a flying manipulator that can hover in any orientation and grasp objects. The drone is even more maneuverable than a quadrocopter and was designed...

Reachy 2: The Open-Source Humanoid Robot Redefining Human-Machine Interaction

March 18, 2025

Reachy 2 was designed to adapt to a wide variety of uses thanks to its modular architecture.

maxon IDX: The plug-and-play solution

March 18, 2025

IDX drives combine power with small space requirements - a brushless BLDC motor combined with an EPOS4 positioning controller and a gearhead inside a high-quality industrial housing...