Archive

Software automates labeling machined holes

June 7, 2007

KeyCreator V6 includes a new Autolabel feature that recognizes the types and sizes of many machined holes, and assigns them a label based on this information.

Staff

The feature works on any hole created in the software, or on imported solids. The software sports direct interfaces to UG, Pro/E, Inventor, SolidWorks, and Catia 4 and 5.

Kubotek USA Inc., 100 Locke Rd., Marlborough, MA 01752, (508) 229-2020, kubotekusacadkey.com

Continue Reading

Multi-axis load cells measure force and torque in six dimensions

Power and efficiency drive motor selection

Sponsored Recommendations

How to Build Better Robotics with Integrated Actuators

July 17, 2024

Reese Abouelnasr, a Mechatronics Engineer with Harmonic Drive, answers a few questions about the latest developments in actuators and the design or engineering challenges these...

Crisis averted: How our AI-powered services helped prevent a factory fire

July 10, 2024

Discover how Schneider Electric's services helped a food and beverage manufacturer avoid a factory fire with AI-powered analytics.

Pumps Push the Boundaries of Low Temperature Technology

June 14, 2024

As an integral part of cryotechnology, KNF pumps facilitate scientific advances in cryostats, allowing them to push temperature boundaries and approach absolute zero.