3D mice for Pro/Engineer

    Feb. 25, 2010
    3Dconnexion’s full line of 3D mice now supports Pro/Engineer Wildfire 5.0.
    3Dconnexion’s full line of 3D mice now supports Pro/Engineer Wildfire 5.0. Users push, pull, twist, and tilt the 3D mouse controller cap to simultaneously pan, zoom, and rotate models or camera views. In addition, 3D mouse keys are pre-configured for the most commonly used Pro/E commands. 3Dconnexion, San Jose, Calif., www.3dconnexion.com
    About the Author

    Leslie Gordon

    Leslie serves as Senior Editor - 5 years of service. M.S. Information Architecture and Knowledge Management, Kent State University. BA English, Cleveland State University.

    Work Experience: Automation Operator, TRW Inc.; Associate Editor, American Machinist. Primary editor for CAD/CAM technology.

    Continue Reading

    Sponsored Recommendations

    April 16, 2025
    Clean. Compact. Less heat.
    April 16, 2025
    SEW-EURODRIVE Introduces DR2C motor, IE5 Ultra-Premium Efficiency Motor
    March 31, 2025
    Unlike passive products - made of simple carbon springs - the bionic prostheses developed by Revival Bionics are propulsive, equipped with a motor and an artificial Achilles tendon...
    March 31, 2025
    Electric drives are a key technology for the performance of machines, robots, and power tools. Download this guide for an introduction to high-quality mechatronic drive systems...

    Voice your opinion!

    To join the conversation, and become an exclusive member of Machine Design, create an account today!