Sikorsky Develops the X2, a Technology Demonstrator for Next-Generation Helicopter Equipment and Controls

July 7, 2009
Sikorsky develops the X2, a technology demonstrator for next-generation helicopter equipment and controls.

Aerospace engineers at Sikorsky Aircraft Co., Stratford, Conn. (www.sikorsky.com), have been developing and testing the X2, a demonstrator aircraft that showcases new helicopter technologies. If all goes as planned, the advances should let tomorrow’s vertical-lift aircraft hover efficiently and still cruise at more than 250 knots, a world record for a helicopter. (The Westland Lynx set a record of 217 knots that has stood for 22 years.)

To simplify hardware but keep the most advanced controls, the two-seat X2 uses fly-by-wire controls that translate pilot inputs into signals for the rotor rpm, the high lift-to-drag blades, low-drag hub fairings, and an active vibration-control system. The craft is powered by a 1,362-shp CTS8000 turbine, a turboshaft engine developed jointly by Rolls-Royce and Honeywell. The engine turns two counterrotating sets of props, which means the tail rotor is no longer needed to counter torque inherent in a single set of rotors. So the “pusher prop” is now used to generate extra thrust.

Edited by Stephen J. Mraz

Sponsored Recommendations

April 16, 2025
Clean. Compact. Less heat.
April 16, 2025
SEW-EURODRIVE Introduces DR2C motor, IE5 Ultra-Premium Efficiency Motor
March 31, 2025
Unlike passive products - made of simple carbon springs - the bionic prostheses developed by Revival Bionics are propulsive, equipped with a motor and an artificial Achilles tendon...
March 31, 2025
Electric drives are a key technology for the performance of machines, robots, and power tools. Download this guide for an introduction to high-quality mechatronic drive systems...

Voice your opinion!

To join the conversation, and become an exclusive member of Machine Design, create an account today!