Low-Viscosity, Melt Adhesive

March 17, 2005
Jet-melt 3750 adhesive is optimized for the high-volume, self-contained Polygun AE II Applicator.

The low-viscosity adhesive has a high flow rate for faster production and good hottack properties cures. It cures in 50 sec. The applicator can feed Jet-melt adhesive at 4 lb/hr, warms to 400°F in 3 min, and has a built-in stand to keep it upright.

3M,
3M Center, Bldg. 220-7E-01,
St. Paul, MN 55144,
(800) 362-3550, 3m.com

Sponsored Recommendations

April 16, 2025
Clean. Compact. Less heat.
April 16, 2025
SEW-EURODRIVE Introduces DR2C motor, IE5 Ultra-Premium Efficiency Motor
March 31, 2025
Unlike passive products - made of simple carbon springs - the bionic prostheses developed by Revival Bionics are propulsive, equipped with a motor and an artificial Achilles tendon...
March 31, 2025
Electric drives are a key technology for the performance of machines, robots, and power tools. Download this guide for an introduction to high-quality mechatronic drive systems...

Voice your opinion!

To join the conversation, and become an exclusive member of Machine Design, create an account today!